Weld toe stress concentrations in multi-planar stiffened tubular KK joints

Date published

2009-01-31T00:00:00Z

Free to read from

Supervisor/s

Journal Title

Journal ISSN

Volume Title

Publisher

Elsevier Science B.V., Amsterdam.

Department

Type

Article

ISSN

0142-1123

Format

Citation

C. O. Woghiren and F. P. Brennan. Weld toe stress concentrations in multi-planar stiffened tubular KK joints. International Journal of Fatigue, Volume 31, Issue 1, January 2009, Pages 164-172

Abstract

This paper reports a parametric stress analysis of various configurations of rack plate stiffened multi-planar welded KK joints using the finite element method. The KK joint finds application in the leg structure of offshore oil and gas jack-up platforms. The rack plate works as a stiffener which reduces the stress concentration at the brace/chord intersection. This could be an immense contribution to the increase in fatigue life of the joint, but other hot spot sites are introduced into the joint. The rack is also used for raising and lowering of the jack-up hull which gives the jack-up platform its jacking capability. Over 120 models using a combination of shell and solid elements have been built and analysed with ABAQUS. Non-dimensional joint geometric parameters (beta, gamma and Omega) are employed in the study, with the new parameter Omega being defined as the ratio of rack thickness to chord diameter. Stress concentration factors (SCFs) are calculated under applied axial and OPB (out-of- plane bending) loading. Three critical SCF locations are identified for each load case, with each location becoming the most critical based on the combination of the non-dimensional parameters selected for the joint. This is important as careful design can shift the critical SCIF from an area inaccessible to NDT to one that can be easily inspected. The SCF values extracted from the models are used to derive six parametric equations through multiple regression analysis performed using MINITAB. The equations describe the SCF at the different locations as a function of the non-dimensional ratios. The equations not only allow the rapid optimisation of multi-planar joints but also can be used to quickly identify the location of maximum stress concentration and hence the likely position of fatigue cracks. This in itself is an invaluable tool for planning NDT procedures and schedules. (C) 2008 Elsevier Ltd. All rights reserved.

Description

Software Description

Software Language

Github

Keywords

Tubular joints Stiffened tubular joints Jack-up platform Multi-planar tubular joints Welded tubular joints Stress concentration

DOI

Rights

Relationships

Relationships

Supplements

Funder/s