Aero engine compressor cooling by water injection - Part 1: Evaporative compressor model

dc.contributor.authorBlock Novelo, David Alejandro
dc.contributor.authorIgie, Uyioghosa
dc.date.accessioned2018-06-19T14:22:39Z
dc.date.available2018-06-19T14:22:39Z
dc.date.issued2018-06-10
dc.description.abstractThe need for more fuel-efficient jet engines has led to a rise in compressor pressure ratio and turbine inlet temperature respectively. The latter has been possible with advancements in turbine blade technology. Nevertheless, this higher temperature during combustion increases the production of thermal Nitrogen Oxides. Contrary to this high-pressure, high-temperature aero-engine design trend, regulations are pushing towards capping or reducing emissions. Injecting atomised water into a jet engine is an alternative to mitigate Nitrogen Oxides that is applied extensively to stationary gas turbines. The application for jet engines is very limited and dates back to the early Boeing 707 and 747 for thrust augmentation. The focus of this study is to investigate the performance benefits of water injection when applied to 2 and 3-spool compressors, under a wide range of different environmental conditions, and for different injection properties. In this first paper, a thermo-analytical compressor model with water droplet investigations in the Lagrangian frame of reference is explored. The methodology is applied to two different engine architectures, representative of modern turbofan engines. This injection study focuses on cooling the core and shows that the percent reduction in compressor discharge temperature is promising over a wider range of ambient conditions than expected. The effect of droplet sizes or quantity utilised were seen to be more influential. The 3-spool compressor also appears to benefit more from water injection in this investigation, mainly due to the higher operating pressures and temperatures found on the Intermediate Pressure Compressor which enables more efficient evaporation, as compared to a booster compressor. Given the design of this compressor, two locations of injections were considered. Reductions in Compressor Discharge Temperature of 60 and 80K were seen for the 2 and 3-spool engines, for a 2% injection ratio, accompanied by reductions in specific compressor work of 16 and 17%. Part 2 of this study has considered boundary conditions obtained here, to investigate the performance and emissions of complete jet engines.en_UK
dc.identifier.citationBlock Novelo DA, Igie I, Aero engine compressor cooling by water injection - Part 1: Evaporative compressor model, Energy, Volume 160, Issue October, 2018, pp. 1224-1235en_UK
dc.identifier.issn0360-5442
dc.identifier.urihttp://dx.doi.org/10.1016/j.energy.2018.05.170
dc.identifier.urihttps://dspace.lib.cranfield.ac.uk/handle/1826/13247
dc.language.isoenen_UK
dc.publisherElsevieren_UK
dc.rightsAttribution-NonCommercial-NoDerivatives 4.0 International*
dc.rights.urihttp://creativecommons.org/licenses/by-nc-nd/4.0/*
dc.subjectCompressoren_UK
dc.subjectWater injectionen_UK
dc.subjectEvaporationen_UK
dc.subjectCoolingen_UK
dc.subjectDropletsen_UK
dc.subjectTurbofanen_UK
dc.titleAero engine compressor cooling by water injection - Part 1: Evaporative compressor modelen_UK
dc.typeArticleen_UK

Files

Original bundle
Now showing 1 - 1 of 1
Loading...
Thumbnail Image
Name:
Aero_engine_compressor_cooling_by_water_injection-2018.pdf
Size:
1.42 MB
Format:
Adobe Portable Document Format
Description:
License bundle
Now showing 1 - 1 of 1
No Thumbnail Available
Name:
license.txt
Size:
1.63 KB
Format:
Item-specific license agreed upon to submission
Description: