Bead shape control in wire based plasma arc and laser hybrid additive manufacture of Ti-6Al-4V

Simple item page
dc.contributor.authorWang, Chong
dc.contributor.authorSuder, Wojciech
dc.contributor.authorDing, Jialuo
dc.contributor.authorWilliams, Stewart W.
dc.date.accessioned2021-07-22T09:30:06Z
dc.date.available2021-07-22T09:30:06Z
dc.date.issued2021-07-16
dc.description.abstractWire based plasma transferred arc (PTA)-laser hybrid additive manufacture has the potential to build large-scale metal components with high deposition rate and near-net shape. In this process, a single bead is the fundamental building block of each deposited component, and thus the bead shape control is essential for the deposition of different geometries. However, how to control the bead shape by manipulating various process parameters is still not understood. In this study, the effect of different process parameters, including laser power, energy distribution between the PTA and laser, wire feed speed, travel speed, and laser beam size on the deposition process and bead shape was investigated systematically. The results show that the optimum operating regime for the hybrid process is with the wire being fully melted by the PTA and the melt pool being controlled by the laser, which gives a good bead shape as well as a stable deposition process. The bead shape is significantly affected by the laser power and travel speed due to the large variation in energy input. The effect of wire feed speed is more complex with the bead width initially increasing to a maximum and then decreasing as the wire feed speed increases. The laser beam size has a minor effect on the bead shape, but a small beam size will result in an irregular bead appearance due to the unstable process caused by the high power density. In addition, a procedure for controlling the bead shape in the hybrid process was proposed, which provided a reference for selection of different process parameters to achieve required bead shapes. The feasibility of this proposed procedure was demonstrated by the two deposited multi-layer single-pass walls.en_UK
dc.identifier.citationWang C, Suder W, Ding J, Williams S. (2021) Bead shape control in wire based plasma arc and laser hybrid additive manufacture of Ti-6Al-4V. Journal of Manufacturing Processes, Volume 68, Pt.A, August 2021, pp. 1849-1859en_UK
dc.identifier.issn1526-6125
dc.identifier.urihttps://doi.org/10.1016/j.jmapro.2021.07.009
dc.identifier.urihttps://dspace.lib.cranfield.ac.uk/handle/1826/16915
dc.language.isoenen_UK
dc.publisherElsevieren_UK
dc.rightsAttribution-NonCommercial-NoDerivatives 4.0 International*
dc.rights.urihttp://creativecommons.org/licenses/by-nc-nd/4.0/*
dc.subjectWire based additive manufactureen_UK
dc.subjectPTA-laser hybrid additive manufactureen_UK
dc.subjectBead shapeen_UK
dc.subjectTitaniumen_UK
dc.titleBead shape control in wire based plasma arc and laser hybrid additive manufacture of Ti-6Al-4Ven_UK
dc.typeArticleen_UK

Files

Original bundle
Now showing 1 - 1 of 1
Thumbnail Image
Name:
Bead_shape_control_in_wire_based_plasma_arc-2021.pdf
Size:
6.1 MB
Format:
Adobe Portable Document Format
Description:
Download
License bundle
Now showing 1 - 1 of 1
No Thumbnail Available
Name:
license.txt
Size:
1.63 KB
Format:
Item-specific license agreed upon to submission
Description:
Download

Collections

Staff publications (SATM)