Single cell Li-Ion polymer battery charge and discharge characterizations for application on solar-powered unmanned aerial vehicle

Date published

2017-01-31

Free to read from

Supervisor/s

Journal Title

Journal ISSN

Volume Title

Publisher

Trans Tech Publications

Department

Type

Article

ISSN

1013-9826

Format

Citation

Rajendran P, Mazlan NM, Smith H. (2017) Single cell Li-Ion polymer battery charge and discharge characterizations for application on solar-powered unmanned aerial vehicle. Key Engineering Materials, Volume 728, 2017, pp. 428-433

Abstract

Solar-powered UAV is an alternative way to achieve high endurance and long range UAV flight. However, solar irradiance is not always available during the flight. Thus, secondary power source which is electrical batteries will improve the performance of solar-powered UAV when solar irradiance is not available. Therefore, bench test for LiPo battery is conducted in this paper for the design of solar-powered UAV power system. The impact of operating temperature at various charging and discharging rate on the duration to full charge and discharge and capacity level of a single LiPo battery were assessed. The solar module installed in solar-powered UAV developed by Aircraft Design Group, Cranfield University has to be designed to charge the battery pack at a nominal or maximum rate of 0.129 C and 0.155 C correspondingly. The solar module requires roughly 5.73 hours on nominal charging rate on 30 °C operating temperature to fully charge capacity level instead of 5.54 hours theoretical predicted. The battery pack will then discharge at cruise flight roughly about 0.071 C to a maximum of 1.685 C if required. If the battery pack is not charged, during cruise flight the battery capacity will deplete completely at about 6.51 hours for the same operating temperature, in contrast to the 6.48 hours based on the theoretical prediction. In addition, the usage of LiPo batteries for operation at high altitudes and/or extreme temperatures without an additional heating or cooling system for these battery packs is not favorable. Thus, it is best to charge at low charging rate and high operating temperature to store and utilize the most capacity from this battery.

Description

Software Description

Software Language

Github

Keywords

Battery Testing, Cumulative Current, LiPo, LiPo Capacity, Solar-Powered UAV, UAV

DOI

Rights

Attribution-Non-Commercial 3.0 Unported (CC BY-NC 3.0) You are free to: Share — copy and redistribute the material in any medium or format, Adapt — remix, transform, and build upon the material. The licensor cannot revoke these freedoms as long as you follow the license terms. Under the following terms: Attribution — You must give appropriate credit, provide a link to the license, and indicate if changes were made. You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use. Information: Non-Commercial — You may not use the material for commercial purposes. No additional restrictions — You may not apply legal terms or technological measures that legally restrict others from doing anything the license permits.

Relationships

Relationships

Supplements

Funder/s