School of Engineering (SoE)
Permanent URI for this community
Browse
Browsing School of Engineering (SoE) by Type "Technical Report"
Now showing 1 - 20 of 71
Results Per Page
Sort Options
Item Open Access Air traffic management accident risk, part 1: the limits of realistic modelling(Cranfield University, 2005-06-27T13:40:21Z) Brooker, PeterThe prime goal of the Air Traffic Management (ATM) system is to control accident risk. Some key questions are posed, including: What do design safety targets really mean and imply for risk modelling? In what circumstances can future accident risk really be modelled with sufficient precision? If risk cannot be estimated with precision, then how is safety to be assured with traffic growth and operational/technical changes? This paper endeavours to answer these questions by an analysis of the nature of accidents, causal factors and practical collision risk modelling. The main theme is how best to combine sound safety evidence and real world hazard analysis in a coherent and systematic framework.Item Open Access Aircraft parameter identification using Matlab(2000)System identification techniques are routinely used in experimental stability and control studies throughout the aerospace industry. Over the years, various researchers at the College of Aeronautics have contributed to this field; most recently some of the latest methods have been employed to estimate the stability and control derivatives of a variety of aircraft types. Although the more recent investigations provide a useful insight into the capabilities and characteristics of several up-to-date methods, they have not resulted in tools which may be used on a routine basis. Consequently, the purpose of this report is to describe a set of procedures which are straightforward to apply, and produce reasonable solutions to the type of linear parameter identification problems which are often found in aerospace work. Recordings of the short period and phugoid modes from Handley-Page Jetstream G-NFLC are used throughout as examples. Firstly, those characteristics of the aircraft’s instrumentation system which influence the quality of the signals - sample rate, antialiasing filters, time delays - are considered. This information is used in conjunction with standard signal processing techniques to ensure that the data is of sufficient quality to be used in the parameter estimation process. Next, a basic Fourier analysis and a least squares algorithm are employed to produce non- parametric and parametric models respectively. The results thus obtained are comparable to those generated using more sophisticated techniques. In conclusion, standard signal processing methods combined with relatively simple estimation theory offer an adequate solution to the linear parameter estimation problem.Item Open Access An analysis of the flight dynamics of a second generation SST aircraft(1999) Steer, Anthony J.This interim report covers an initial overview of delta-wing aircraft static, dynamic and control characteristics, collated from publications within the public domain and the authors related research. This is to give the reader an overall understanding how a delta-winged supersonic transport aircraft’ s characteristics differ to those of a conventional civil transport aircraft. This is followed by identifying the aircraft’s static and dynamic stability, with the effect of speed and CG location on the aircraft dynamic modes specifically addressed. Following this, a comprehensive investigation and analysis of the open loop response of a SCT baseline aircraft, in both low-speed cruise and approach and landing conditions, has been carried out. Both time and frequency domain techniques have been utilised. Finally, conclusions are made based on the results of the work presented.Item Open Access The application of a C* flight control law to large civil transport aircraft(1993) Field, EdmundThe work contained in this report is part of an on-going programme of research into handling qualities of fly-by-wire civil transport aircraft currently being undertaken within the Flight Dynamics Group of the College of Aeronautics . Although much work has been undertaken into handling qualities of military aircraft over the last 30 years, civil aircraft have received considerably less attention. Over the last decade civil transport aircraft incorporating fly-by-wire flight control systems have been introduced into commercial operation, the latest including some modified aerodynamic designs. However the civil arena lacks the supporting research into handling qualities that the military side has enjoyed. More recently the civil side is beginning to receive the attention it deserves with work in Europe by Fokker and the Group for Aeronautical Research and Technology in EURope (GARTEUR), for example. In the United States much work has been done by the manufacturers such as Boeing and McDonnell Douglas, and as ever work supported by the US Air Force and NASA. The primary aim of this current programme is to design flight control laws to give fly-by-wire civil transport aircraft excellent flying qualities at all flight conditions, but especially in piloted flight phases. The most critical flight phase of a civil transport is that of the landing approach, and, as with other studies of this type, this phase receives the greatest attention in this study. This report concerns an analysis of the C* parameter. The C* criterion was one of the first handling qualities criteria designed to take account of advanced aerodynamic designs of modern aircraft and higher order systems introduced by flight control systems. Several aircraft have since employed control laws based around the C* parameter. A proportional feedback C* controller was applied to a Boeing 747-100 in landing approach configuration, and assessed against the C* criterion and the US military specification MIL-STD- 1797A.Item Open Access Arbitrary-order high resolution schemes for model hyperbolic conservation laws(1992) Shi, JianThis report investigates the general theory and methodology of high resolution numerical schemes for one-dimensional hyperbolic conservation laws. The Universal Formula from which 2-level explicit conservative arbitrary-order numerical methods can be derived is developed. This report also explores the issue of linear stability. A new approach to linear stability analysis is presented. The generalized formulation for TVD methods with stable region of -1 ≤ c ≤ 1 proposed. To demonstrate the theories, some third order and fourth order TVD methods are generated.Item Open Access Arbitrary-order numerical schemes for linear hyperbolic systems(1992) Shi, JianThis report is an extension of the work carried out in [16]. In [16] we defined arbitrary-order numerical methods for model scalar hyperbolic equation. In this report we extended these methods to linear hyperbolic systems where waves can propagate in both directions. First, we define a generalized numerical formula which can accommodate arbitrary wave speeds for scalar advection equation. Then to illustrate its application, we derive three, four, and five point generalization numerical schemes. Finally, according to the theory of linear systems, we extend the generalized schemes to linear hyperbolic systems in a straight forward manner.Item Open Access Arbitrary-order numerical schemes for model parabolic equation(1992) Shi, JianThis report investigates the general theory and methodology of high order numerical schemes for one-dimensional model parabolic equation. The Universal Formula from which a 2-level explicit arbitrary-order numerical methods for diffusion equation can be derived is developed. Using the Universal Formula some high order numerical methods are constructed. Some important features of numerical methods are revealed through the construction of high order numerical methods and stability analysis. Subject to the limitation of diffusion number, d, being positive, only the method that satisfies positive stable region is relevant.Item Open Access Cardiovascular and subjective measures of task demand in a low workload monitoring task : summary report(Cranfield Institute of Technology; College of Aeronautics, 1987) Braby, Carole D.Item Open Access Comparison if the convergence behaviour of three linear solvers for large, sparse unsymmetric matrices(1995) Shaw, ScottImplicit methods for the calculation of unsteady flows require the solution of large, sparse non-symmetric systems of linear equations. The size of such systems makes their solution by direct methods impractical and consequently iterative techniques are often used. A popular class of such methods are those based upon the conjugate gradient method. In this paper we examine three such methods, CGS, restarted GMRES and restarted GMRESR and compare their convergence properties.Item Open Access Comparison of the time vector method and the state-space method (Eigenvector analysis) for aircraft parameter identification(1996) Baek, Y.Many methods for aircraft parameter identification have been developed and are currently in use. Prior to the development of computer methods the graphical Time Vector Method (TVM) was introduced during 1950’s (ref.1,2). Basically the TVM is based on the mechanical vibration theory. When the aircraft responses have oscillatory modes they can be considered as vibrations even though the typical frequency of these may be higher than those of the mechanical vibrations. Because of the graphical approach, the TVM may produce inaccurate results. But it gives use thorough understanding of the physical system. Owing to the rapid development of computers and sophisticated parameter identification algorithms, the rather limited graphical method has fallen into disuse and the other have emerged to replace it. They are, typically, the output error methods, the equation error methods, the Kalman filter estimator, the maximum likelihood technique, and so on (ref. 3~6). The damping angle, natural frequency, relative magnitude and phase angle of each dynamic mode are the basis of the TVM. In this respect the state-space models can provide the same information. In particular the eigenvalues and eigenvectors which involve all the response information of the system, have the same properties as the time vectors. So, the objective of this report is to shown the relationship between the TVM and the state-space method of an analysis and hence to facilitate the state-space method (eigenvector analysis) for aircraft parameter identification.Item Open Access Compressible Flow Produced by Distributed Sources of Mass: An Exact Solution(Aerodynamics, Cranfield Institute of Technology, 1987-07) Clarke, J. F.The paper considers the case of a one-dimensional isentropic unsteady compressible flow that is driven entirely by a distribution of sources in the left-hand half space of an unbounded domain. The right-hand half-space contains no sources, so that source-strength drops discontinuously to zero as one crosses from left to right-hand space. Exact solutions are obtained for those parts of the flow that remain isentropic.Item Open Access Computer-aided conceptual aircraft design (CACAD) for transport aircraft(1996) Vaziry-Zanjany , Mohammad Ali (F)CACAD is capable to optimise the size, and configurations of turbofab-powered transport aircraft. The synthesis sizes aircraft from the low-capacity short range Fokker F-100 class to the long range medium-capacity Airbus A-340 class. It has an optimisation capability, with the objective function being direct operating cost in which, maintenance costs is extensively sub-divided according to ATA chapters. The objective of this report is to present the listing, the user's guide on how to run the program, as well as the description of the formulation used within the program. There are flow charts, table of nomenclatures included in this report. The floppy disc that contains the programme listings will be made available on request from the office of Department of Aerospace Technology, College of Aeronautics, Cranfield University, Cranfield, Bedford, UK, MK43 0ALItem Open Access Control jet-slender body performance characteristics at hypersonic speeds(1995) Kontis, KonstantinosThe jet control effectiveness of a 5 deg semi-angle cone has been tested at hypersonic speeds. The study has been carried out in the Cranfield hypersonic gun tunnel facility at a Mach number of 8.2, and a Reynolds number based on base diameter of 3.788 x 10(5). Under those conditions, the initial boundary layer in the absence of the jet was laminar. The jet was injected normal to the cone surface at sonic speed. Both sharp and blunted cones were used. The Jet/flowfield interaction, including boundary-layer separation and its influence upon aerodynamic coefficients was determined. Pressure and force measurements were made in the incidence range of -15 deg to 15 deg. The forces were measured with a 3-component balance equipped with semi-conductor strain gauges. The flow structure was studied using high speed schlieren photography. Jet penetration distances have been compared with theoretical estimates.Item Open Access Cranfield situation awareness scale: Users Manual(1997) Dennehy, KTraining to enhance situation awareness depends upon having satisfactory quantitative methods for measuring situation awareness. Until the development of the Cranfield-SAS, there was no direct subjective rating scale to measure the situation awareness of student (ab initio) civil pilots (see appendix 4 for an overview of the measurement guidelines for an overview of the measurement guidelines for scale development). The development of the scale was part requirement for a Ph.D. at Cranfield University. The benefits of such a technique is that a pilot’s progress in developing the skills necessary for situation awareness can be monitored. Instructors specifically can enhance the situation awareness of ab initio civil pilots in terms of: • Workload • Decision making • Design and Performance • Training The “Cranfield-Situation Awareness Scale (SAS)” is based on pilot actions and knowledge that the aviation community considered important to maintaining situation awareness. In general situation awareness refers to pilots knowledge and understanding of the situation in relation to the requirements of the flight task. The “Cranfield-SAS” is a subjective assessment technique and was developed as either an observer-rating (i.e. by instructors) or as a self-rating (i.e. by student pilots) during different predefined flight tasks (see appendix 3 for overview of observer/self-ratings). It is intended that this technique should ultimately be used during flight, flight simulation, or in the debriefing session. This users manual outlines how to use the Cranfield-SAS and has been distributed to instructors at flight schools (i.e. Great Britain and Canada) and to a major airline. The scale remains ownership of Cranfield University buy may be photo-copied (or requests for additional copies) and used freely by both instructors and students (for self-evaluation). As the scale is still under evaluation, we would request that the registration form (presented on a green page in the last page of the manual) be returned to: Dr. C.D. Deighton at the Applied Psychology Unit, Cranfield University. A short questionnaire will then be sent to you to obtain your comments on the structure and content of the scale.Item Open Access Descriptions of Cranfield Aircraft Group design projects (1979-96)(1996) Fielding, J. P.This report is a compilation of reprints of papers and articles describing the aircraft design group projects for the period between 1979 to 1996. In Crdeld projects, each student takes responsibility for part of the design of a project aircraft, which is used as a design case study for the whole group of students of the course. This teamwork exercise, with specified individual tasks, is organised on the lines of a project as carried out in industry. It is undertaken over eight months, in parallel with the lectures and individual research studies. It is assisted by displays of aircraft components and manufacturing processes, and field visits are made to aircraft manufacturers and operators. The nature of the course and the future occupations of the students, give guidance to the choice of subject aircraft. The aim is to ensure industrial relevance, but also to include a significant research element in each project. The size of the course usually precludes the design of light aircraft. It is usual to alternate between civil and military aircraft, and each project has a unique configuration.Item Open Access The Design of Michell Optimum Structures(Cranfield College of Aeronautics, 1960-12) Chan, A. S. L.The fundamental problem of structural design is the determination of structures of minimum weight which safely equilibrate a given system of external forces. The classical theorem of Michell gave basic requirements for such a structure. The first part of this paper analyses the geometrical layout of two-dimensional structures which satisfy these requirements, making use of the analogy with the theory of plane plastic flow. Expressions for the calculation of sizes and the total volume of the structural members are developed. Method of graphical construction of the structural layout is also given.Item Open Access Design Synthesis for Canard-Delta Combat Aircraft (Optimization)(Cranfield Institute of Technology; College of Aeronautics, 1988-10) Serghides, V. C.Item Open Access Development of satellite telecommunications during the period 1990-2005(1993) Kumar, D.The global telecommunications market is in the midst of a radical restructuring program. This is driven by the desire of governments to increase competition in existing markets and of companies to diversify their service product portfolio. These changes are taking place as a result of advances in technology as well as three powerful and interconnected forces – privatisation, globalisation and liberalisation. Introduction of new technologies in the form of Integrated Services Digital Networks ((ISDNs)and sophisticated integrated terminal equipment has resulted in the transformation of the telecommunications services market from mainly a single service industry limited by technology constraints into a multi-service industry limited by applications. As a result of privatisation and globalisation, the former national telecommunications carriers are beginning to expand overseas in order to grow. In regions where the market regulations have been liberalised, the changes have effectively shattered the highly protected and monopolistic national markets. These changes when incorporated into the present satellite communications industry indicate a shift in traffic structure as well as in the global satellite market structure.Item Open Access The drag of spheres at porosites ranging from an isolated sphere to a packed bed(Cranfield Institute of Technology. College of Aeronautics, 1990) Pike, J.Item Open Access The effect of longitudinal stagger on the aerodynamic interference between two axisymmetrical bodies whose centrelines are parallel, at zero pitch and are separated by 1.05 body diameters(Cranfield Institute of Technology; College of Aeronautics, 1989) Llewelyn-Davies, D. I. T. P.; Hussain, Z.