Browsing by Author "Yang, Shouliang"

Now showing 1 - 2 of 2
  • Thumbnail Image
    ItemOpen Access
    Micropore evolution in additively manufactured aluminum alloys under heat treatment and inter-layer rolling
    (Elsevier, 2019-10-28) Gu, Jianglong; Yang, Shouliang; Gao, Minjie; Bai, Jing; Zhai, Yuchun; Ding, Jialuo
    The application of wire + arc additively manufactured (WAAM) aluminum alloys has been restricted by the porosity defect, which is generally detrimental to the mechanical properties. Suppressing of micropores in the WAAM components has attracted considerable attention in recent years. Inter-layer rolling was introduced to eliminate micropores during the WAAM deposition of the Al–Cu6.3 and Al–Mg4.5 alloys. The distribution characteristics and individual morphology of micropores were revealed by the X-ray diffraction tomography. Key findings demonstrated that the number, volume, size, and roundness of micropores in rolled alloys decreased similarly with increasing loads, eventually achieving a density of over 99.9%. After the heat treatment, the homogeneous distribution of fine (around 5.3 μm) and spherical (0.70–0.74) micropores was realized in the 45 kN rolled alloys. All the evaluated indicators of micropores in the 45 kN rolled + heat treated alloys were superior to the post-deposition heat treated state. The evolution mechanisms include the reprecipitation of hydrogen pores, formation of vacant voids, and re-opening of unclosed pores. The hybrid technique of WAAM + rolling + heat treatment has great potential in promoting mechanical properties of WAAM alloys. The results will provide a theoretical guidance for the design of high-performance WAAM aluminum alloy components.
  • Thumbnail Image
    ItemOpen Access
    Microstructure, defects, and mechanical properties of wire + arc additively manufactured AlCu4.3-Mg1.5 alloy
    (Elsevier, 2019-11-13) Gu, Jianglong; Gao, Minjie; Yang, Shouliang; Bai, Jing; Zhai, Yuchun; Ding, Jialuo
    The wire with a composition of AlCu4.3%Mg1.5% was customized and used to deposit the WAAM alloy with the power source of cold metal transfer. The microstructure, defect, and mechanical properties of the as-deposited and heat-treated WAAM alloys were studied. Key findings demonstrated that the microstructure of the as-deposited alloy was characterized by a hierarchical distribution of dendrites, equiaxed grains, and a slight number of columnar grains. The volume fraction of the network-like scattered coarse particles of second phases θ + S reduced by 95% after the T6 heat treatment. With an average microhardness of 161.4 HV, the mean yield strength and ultimate tensile strength of the WAAM alloy increased by 116% and 66% achieving 399 MPa and 485 MPa in the horizontal direction after heat treatment. The precipitation of a high density of needle-shaped metastable S′ precipitates was responsible for the significantly enhanced mechanical properties. However, this WAAM alloy has exhibited an anisotropic tensile property. A considerable number of sharp-angled defects like linear and chain-like micropores, which generally depress the mechanical properties, were formed in the WAAM alloys.