Browsing by Author "Williams, J.G."
Now showing 1 - 1 of 1
Results Per Page
Sort Options
Item Open Access Impact perforation testing of stab-resistant armour materials(1995-12-31T00:00:00Z) Horsfall, Ian; Pollitt, S. M.; Belk, J. A.; Angood, C.; Williams, J.G.; Pavan, A.This paper describes the development of a method for the investigation and comparison of materials for use in stab resistant body armour. A number of polymer composite panels of different thicknesses and construction have been tested. A dynamic test which simulated the real threat has been used and the results compared to a simpler quasi-static test that might be used in initial materials selection. The materials tested were glass-epoxy, and glass-nylon composite panels of several thicknesses between 1.8 and 5.8mm. Additional tests were also performed on similar composites containing tungsten wires. An accelerated instrumented drop-tower was used to drive a knife through composite panels and record the force resisting penetration by the knife. The final penetration of the knife through the armour into a soft backing was also measured. For comparison,a similar geometry quasi-static test was carried out on the same specimens. It was found that energy absorbtion took the form of an initial resistance to perforation and then by a resistance to further penetration. This is thought to stem from resistance to cutting ofthe panel material and gripping of the knife blade. The energy required to produce a given penetration in dynamic tests was found to be in good agreement with the penetration achieved at similar energies under quasi-static conditions. For the materials tested there was no significant difference between the penetration resistance of single or two layer systems. The penetration achieved through a panel of a given material was approximately proportional to the inverse square of the panel's thickness. The relative performance of different armour materials was assessed by plotting the energy required to penetrate a fixed distance against the areal density of the panel.