Browsing by Author "Stocking, Philip"
Now showing 1 - 1 of 1
Results Per Page
Sort Options
Item Open Access Novel swing arm mechanism design for trailing edge flaps on commercial airliner(Cranfield University, 2008) Yu, Jie; Stocking, Philip; Lawson, CraigThis thesis will describe the works had been done by the author in the Flying Crane aircraft group design project and the new design of a novel swing arm mechanism which can be applied in the trailing edge high lift devices for this aircraft concept. Flying Crane aircraft is a new generation commercial airliner concept as the result of group design project conducted by China Aviation Industry Corporation I (AVIC I) and Cranfield University. At the end of the group design project, parameters such as take-off and landing distance, trailing edge flap type and deflection in take-off and landing configuration of the Flying Crane concept have been determined. These parameters are design input of the novel trailing edge high lift device mechanism for this aircraft concept. The idea of this innovative mechanism comes from the research achievement of a previous MSc student, Thomas Baxter, which applied swing arm mechanism into a passenger aircraft's leading edge slat. This thesis applied this idea to trailing edge flap and modeled the mechanism on CATIA software to yield a kinematic simulation for the purpose of check motion trail and force transfer in this mechanism. Relevant works such as actuation, mass and stress analysis are also involved. As the result of this research project, it was found that swing arm mechanism trends to require relatively small fairings for supports and attachments due to its high stowed space utilizing efficiency. Initial mass estimation carried out in this thesis also indicates that the new design takes advantage in terms of weight comparing with traditional trailing edge flap mechanisms. Thus. swing arm mechanism is supposed to show great competitive potential for commercial airliner's trailing edge flaps after further analysis has been done in the detail design phase.