Browsing by Author "Ahmed, Umair"
Now showing 1 - 3 of 3
Results Per Page
Sort Options
Item Open Access Development of a far-field noise estimation model for an aircraft auxiliary power unit(IEEE, 2021-09-14) Ahmed, Umair; Ali, Fakhre; Jennions, Ian K.Aircraft Auxiliary Power Unit (APU) is one of the major aircraft systems and is reported to be a key driver of unscheduled maintenance. So far, the research has been focused on the implementation of the APU thermodynamic state data to isolate and diagnose faults. To advance the available diagnostic techniques, research work has been initiated to explore the potential of employing far-field microphone data for the identification and isolation of APU faults. This paper aims to address the first step required in the overall effort and proposes a novel methodology for the development of a noise model that can be used for evaluating noise as a source of fault diagnostics. The methodology integrates experimentally acquired full-scale aircraft state and noise data, a physics-based APU thermodynamic model, and semi-empirical noise models to estimate the noise produced by an aircraft APU based on a limited parameter-set. The methodology leads to a model which works by estimating the unknown thermodynamic parameters from the limited dataset and then passes on the relevant parameters to noise estimation models (combustion/jet noise models). An inherent part of the model is the effect of multipath propagation and ground reflections for which a relationship has been analytically derived that considers all the necessary parameters. The developed model has been validated against experimental noise and thermodynamic data acquired from a Boeing 737-400 aircraft APU under several different operating conditions. The acquired noise estimates suggest that the proposed approach provides an accurate estimation of the far-field noise under a wide range of APU operating conditions, both at the sub-system and APU level. The model would act as an enabler to simulate APU noise data under degraded functional states and subsequently developing fault diagnostic schemes based on the far-field noise data.Item Open Access A review of aircraft auxiliary power unit faults, diagnostics and acoustic measurem(Elsevier, 2021-04-30) Ahmed, Umair; Ali, Fakhre; Jennions, IanThe Auxiliary Power Unit (APU) is an integral part of an aircraft, providing electrical and pneumatic power to various on-board sub-systems. APU failure results in delay or cancellation of a flight, accompanied by the imposition of hefty fines from the regional authorities. Such inadvertent situations can be avoided by continuously monitoring the health of the system and reporting any incipient fault to the MRO (Maintenance Repair and Overhaul) organization. Generally, enablers for such health monitoring techniques are embedded during a product's design. However, a situation may arise where only the critical components are regularly monitored, and their status presented to the operator. In such cases, efforts can be made during service to incorporate additional health monitoring features using the already installed sensing mechanisms supplemented by maintenance data or by instrumenting the system with appropriate sensors. Due to the inherently critical nature of aircraft systems, it is necessary that instrumentation does not interfere with a system's performance and does not pose any safety concerns. One such method is to install non-intrusive vibroacoustic sensors such that the system integrity is maintained while maximizing system fault diagnostic knowledge. To start such an approach, an in-depth literature survey is necessary as this has not been previously reported in a consolidated manner. Therefore, this paper concentrates on auxiliary power units, their failure modes, maintenance strategies, fault diagnostic methodologies, and their acoustic signature. The recent trend in APU design and requirements, and the need for innovative fault diagnostics techniques and acoustic measurements for future aircraft, have also been summarized. Finally, the paper will highlight the shortcomings found during the survey, the challenges, and prospects, of utilizing sound as a source of diagnostics for aircraft auxiliary power units.Item Open Access Signal processing of acoustic data for condition monitoring of an aircraft ignition system(MDPI, 2022-09-19) Ahmed, Umair; Ali, Fakhre; Jennions, IanDegradation of the ignition system can result in startup failure in an aircraft’s auxiliary power unit. In this paper, a novel acoustics-based solution that can enable condition monitoring of an APU ignition system was proposed. In order to support the implementation of this research study, the experimental data set from Cranfield University’s Boeing 737-400 aircraft was utilized. The overall execution of the approach comprised background noise suppression, estimation of the spark repetition frequency and its fluctuation, spark event segmentation, and feature extraction, in order to monitor the state of the ignition system. The methodology successfully demonstrated the usefulness of the approach in terms of detecting inconsistencies in the behavior of the ignition exciter, as well as detecting trends in the degradation of spark acoustic characteristics. The identified features proved to be robust against non-stationary background noise, and were also found to be independent of the acoustic path between the igniter and microphone locations, qualifying an acoustics-based approach to be practically viable.